OPTIMUM
M A S C H I N E N - G E R M A N Y
Version 1.1.3 dated 2016-7-5
Page 35
Original operating instructions
BF46 Vario | BF46TC
GB
Also with a quick on and off, this overload occur. Therefore wait for about 3 seconds
before you switch on the drilling-milling machine again, the capacitors in the controller
must first discharged.
4.8
Switching off the drilling-milling machine
Press the push button "OFF". For a long-term standstill of the drilling-milling machine switch
it off at the main switch.
4.9
Traveling the drilling milling head (Z-axis) upward respectively downward
It is possible to perform the height adjustment of the drilling milling head by actuating the crank
handle or the control panel
4.9.1 Traveling the drill-mill head upward respectively downward by actuating the crank
handle
Img.4-6: Drilling milling head - height adjustment
Img.4-7: Clamping lever
Release clamping lever (2).
Engage the handle (1) by pushing it towards the teeth.
Crank the drilling milling head to the required position.
Clamp if needed.
1
2
1
Crank handle
2
Clamping lever
