OPTIMUM
M A S C H I N E N - G E R M A N Y
Version 1.1.3 dated 2016-7-5
Page 71
Original operating instructions
BF46 Vario | BF46TC
GB
8
Appendix
8.1
Copyright
This document is copyright. All derived rights are also reserved, especially those of translation,
re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar means and
recording in data processing systems, neither partial nor total.
Subject to technical changes without notice.
8.2
Terminology/Glossary
8.3
Change information manual
Term
Explanation
Cross table
Bearing surface, clamping surface for the workpiece with X- and Y-axis
travel
Taper mandrel
Cone of the drill or of the drill chuck
Workpiece
Piece to be milled, drilled or machined.
Draw-in rod
Threaded rod to fix the taper mandrel in the spindle sleeve.
Drill chuck
Drill bit chuck
Collet chuck
Holder for end mill
Drill-Mill head
Upper part of the drilling-milling machine
Spindle sleeve
Hollow shaft in which the milling spindle turns.
Milling spindle
Shaft activated by the motor
Drilling table
Supporting surface, clamping surface
Taper mandrel
Cone of the drill or of the drill chuck
Spindle sleeve lever
Manual operation for the drill feed
Quick action - drill
chuck
Drill chuck can be fixed by hand.
Workpiece
Piece to be drilled or machined.
Tool
Milling cutter, drill bit, etc.
Chapter
Short note
new version number
4.3
Warming up of the drilling-milling machine
Fast on and off.
1.1.1
CE declaration
1.1.2
4.17
New digital display for spindle sleeve travel
1.1.3
