slide until
all ridges are covered
look for ridges
on
each
side
of strip
Step 4: Install Connectors
28
cabled.optiled.com
IMPORTANT: The connectors consist of two parts, a top and bottom, which are
partially assembled at the factory. DO NOT push the connectors together before you
are ready to install.
!
4.7 Install U-Connector
Connects two CabLED strips parallel with each other for twice the brightness or to achieve a
balance of warm and cool colors.
A
Remove the protective piece from
U-Connector. With the LED side of each strip
facing up, insert each CabLED strip into the
U-Connector and push to the end.
C
Using pliers, apply even pressure to the bottom and top connector to push connector
together, securing CabLED strips inside.
B
Push both strips completely into the
connector. The ridges on each side of the
strips will be covered when the strip is
properly installed.
IMPORTANT: When using pliers that do not cover the entire surface of the connector, hold the
connector and strip steady so the CabLED strip remains in position. Carefully rotate the pliers
and apply pressure to each side of the connector, pushing the top and bottom together.
!
D
Make sure both sides of the bottom half of the connector snap into
the top half. Gently pull the CabLED strips to make sure you have
installed them properly.