Step 6: Mount CabLED™
cabled.optiled.com
35
B
Push the stakes firmly into the ground spaced
from 12 to 16 inches (31-41cm) apart.
A
Set the angle by fitting the mounting clip
into the stand at the desired angle.
C
Insert CabLED strip into one side of bottom
channel and snap into place.
Position so strip lays flat and LEDs are NOT
covered when strip is installed. Reposition
stake if necessary.
Install Garden Stake
The Garden Stake consists of two pieces, the mounting clip and the stand, which are assembled
to angle the direction of the light between 0 and 135 degrees at 11.25 degree intervals.
The mounting clip, is designed with two cavities. Install the CabLED strip alone in the bottom or
the CabLED strip with the Channeling into the top. Follow the instructions for each method for
the easiest installation.
IMPORTANT: Use Garden Stakes where CabLED will be installed on the ground
outside. Install so CabLED or connectors will NOT be submerged in water.
Angle marked on
outside stand
The Garden Stakes are two-piece mounts designed to hold the CabLED strips along pathways and
can be set so the light is directed at an angle between 0 and 135 degrees at 11.25 degree intervals.
The mounting clip is designed with two cavities to either hold the strip alone, or for added
support, with the Channeling.
NOTE: Installation shown at 0 degree angle.
!
