cutting point
one
cutting point
one
cutting point
two
cutting point
one
cutting point
two
Step 3: Begin Installation
22
cabled.optiled.com
3.1 Measure, Mark and Cut CabLED™
Now that you have planned where the CabLED will be placed in each section of your installation,
it is important to double check before you cut each strip.
3.2 Mark CabLED™
CabLED can ONLY be cut every 7.09 inches (18cm) and must be cut EXACTLY on the cut line.
Hold the strip up to the surface you marked in Step 2, locate nearest cut line and mark it on the
strip. Repeat for each section.
3.3 Cut CabLED™
Use a pair of sharp scissors to cut the CabLED strip EXACTLY on the cut lines you have marked.
NOTE: If there is a large discrepancy in your measurements, make sure you have selected
the correct components to complete your installation.
A
B
IMPORTANT: The CabLED strip may ONLY be cut every 7.09 inches (18cm),
indicated by a cut line on the LED side of the strip. When you are measuring for your
installation, if the total length in inches is not a multiple of 7, then adjust the plan of
your layout to use the nearest cut line marked on the strip.
!
