slide until
all ridges are covered
look for ridges
on
each
side
of strip
Step 4: Install Connectors
cabled.optiled.com
25
D
Make sure both sides of the bottom half of the connector snap into
the top half. Gently pull the CabLED strips to make sure you have
installed it properly.
A
Remove the protective piece from both sides
of the Jumper Connector. With LED side
facing up, slide one CabLED strip into the
opening in bottom half of one side of the
connector until it reaches the end. Repeat
with the other CabLED strip in the other side
of the connector.
B
Push the strip completely into the connectors.
The ridges on each side of the strip will be
covered when the strip is properly installed.
The Jumper Cable connects two CabLED strips with a flexible cable. They are available with 2",
4”, 6”, 12”, 24” and 40” cables. Use the shorter lengths for connecting two CabLED strips at any
angle, or when the strips do not meet at 90 degree angles after being centered to a section.
The medium lengths are often used for stairs, running strips parallel with each other with space
between them. The longer lengths are useful when running strips under sections of kitchen
cabinets with an appliance between them, extending the system behind a larger area.
4.4 Install Jumper Cable
C
Using pliers, apply even pressure to the bottom and top halves of each
connector to push them together, securing the CabLED strips inside.
IMPORTANT: The connectors consist of two parts, a top and bottom, which are
partially assembled at the factory. DO NOT push the connectors together before you are
ready to install.
!
IMPORTANT: When using pliers that do not cover the entire surface of the connector, hold
the connector and strip steady so the CabLED strip remains in position. Carefully rotate the
pliers and apply pressure to each side of the connector, pushing the top and bottom together.
!