38
Export “File Transfer” or “Manual Input” Setup File
Pushing either of these buttons will create a setup file with a default name of “std.set” or “manual.set”.
When this is done, you should rename this file to a descriptive name for the finishing process or job it is to
be sued on and later loaded onto the controller. The “File Transfer” button will create a properly formatted
file for downloading using the optional Computer File Storage Interface upgrade. The “Manual Input”
button will create a properly formatted file that allows easy entry into the controller using the keypads.
Typical “File Download” Calibration Setup File
RECEIVE_NAME=
ProcessA.set
FILENAME=
ProcessA
START_INPUT=
MEAS
RA_UNITS=
MICROINCHES
RA_LIMITS= 15.00 20.00
LOW_ANALOG=
15.00
HIGH_ANALOG=
20.00
RA_THRESHOLD=
12.00
CAL_TYPE=
EXPONENTIAL
CAL1= -0.50
5.90
0.00
1.10
CAL2= 0.00
4.80
0.60
5.10
CAL3= 1.20
-7.44
31.81 MAX
CAL4=
CAL5=
EOF
Typical “Manual Input” Calibration Setup File
FILENAME=
ProcessA
Cal_A1: -0.50
Cal_B1: 5.90
Cal_C1: 0.00
Cal_A2: 0.00
Cal_B2: 4.80
Cal_C2: 0.60
Cal_A3: 1.20
Cal_B3: -7.44
Cal_C3: 31.81
Break_1:
1.10
Break_2:
5.10
Threshold:
12.00
RA_UNITS=
MICROINCHES
Calibration Coefficients
Values referred to as Cal_A1, Cal_B1, through to Cal_C3 represent “a, b, c” values in each of the three
regions of “ax
2
+ bx +c” calibration equations.
Break Points
Break_1 and Break_2 indicate the raw uncalibrated Ra values that software switches between calibration
regions.
