Power (OFF)
2
3
・
Be sure to use the power supply of
100 to 240 VAC.
Otherwise it may cause fire or
electric shock.
・
Do not wipe the
Transmitter with solvent.
It may cause failure.
・
To clean the
Transmitter, first wipe
away lightly with a clean
soft cloth damped by
diluted mild detergent
solution and then wipe
off moisture with a dry
clean soft cloth.
100 to 240 VAC
Organi
c
Solvent
Thinner
etc.
・
There are high
voltage parts inside
the Transmitter.
Failure to observe
this precaution may
cause fire or an
electric shock.
・
Do not give a strong shock to the
Transmitter.
・
Do not press the CLEAN button, while
the SS Checker (Detector) is in the air.
・
Make sure that the Cover is locked
without fail. Otherwise, protective
structure may not function adequately.
Keep the Power off during
installation and wiring operations.
・
Use Cable Clamps attached to the
transmitter for wiring. When the piping
are directly connected with the
transmitter, take a corrective action
such as caulking against intrusion of
gas because corrosive gas is in danger
of intruding through the piping, etc. into
the Transmitter.
・
Do not bind the signal output cable with
the power cable or do not put them in
the one Cable Clamp.
・
Install the transmitter
with attached
Mounting Bracket.
・
Install the transmitter at a place
ventilating well and avoiding direct
sunlight.
・
Do not disassemble or modify the
Transmitter. Disassembly or
modification may cause fire or an
electric shock because there are high-
voltage parts inside the Transmitter.
・
Turn off the Power immediately
i
n the
unlikely event that there occur any
abnormalities such as smoke or
abnormal noise. Otherwise it may
cause fire or an electric shock.
Please thoroughly read the "For safe use" before using the SC-T4
properly.
Because these precautions are related to failure or malfunction,
observe the precautions for use without fail.
In order to use the SC-T4 properly,
observe the following precautions.
Precautions which are the cause of failure:
The SC-T4 is used exclusively to SS Checker (Detector).
Accordingly, do not connect other equipment.
[Be sure to read this instruction manual in order
to use the Transmitter SC-T4 properly.]
1
For safe use
" " denotes "Prohibited action", and " " denotes "Required action".
