1
ABOUT THE RADIO SYSTEM
ZTX-700
ST. Trim Dial
TH. Trim Dial
* In general, user will experience under steer when making a wide turn at high speed or
over steer when making sharp turn at high speed (easy to spin out). User should practice
the Throttle and steering approach for different cornering at different speed or road surface.
Battery Installation
The following is an overview of the various functions and adjustments found on ZTX-700 radio system for Z-CAR models. It is important to read
and understand about all of these functions and adjustments before driving.
Z-CAR ZTX-700 2.4GHz FHSS Technology System
FUNCTIONS
TRANSMITTER ZTX-700
2.Install the batteries
observing the polarity
marked on battery
compartment.
3.Then reinstall the battery
compartment cover as the
Picture shown below.
Warning :
Never disassemble batteries or put the
batteries in fire, chemical agents, otherwise
they may cause personal injuries or property
damages.
Battery Disposal :
Observe corresponding regulations about
wasted battery treatment regulations.
1. After running out of power, dispose of
wasted batteries in designated areas far
away from water supply, household areas
and planted areas.
2. Submit the wasted batteries to specific
recycling stations.
Battery LED Indicator
The Green LED indicator located on the front left side of the transmitter indicates
the power supply of batteries. The green LED will go solid on indicating that
the batteries have sufficient power. When batteries voltage drops below 4
volts, LED will turn to Flashing RED, indicating the batteries power is low and
should be replaced.
Pre-Run Check
Steering
Wheel
Throttle Trigger
LED
Indicator
Steering
Reverse
Throttle
Reverse
ATV
FTN Key
ON/OFF
Switch
* Always turn on the transmitter first by sliding
the switch on the left side from bottom to top.
The small red and green lights above the
switch should both light up. If not, you need
to check for low or incorrectly installed
batteries.
1. Steering : Adjust the steering trim to keep
the front wheels in straight line when steering
wheel remains in NEUTRAL position.
2. Throttle : Adjust the throttle trim to ensure
the rear wheels stop rotating when throttle
trigger remains in NEUTRAL position.
GREEN
GREEN
Solid GREEN :
Sufficient Power supply
Flashing RED :
Time to replace batteries
1
2
3
Steering Wheel :
Control direction (Left/Right) of the RC model.
Throttle Trigger :
Control speed and direction (Forward/Brake/Backward)
of the driving model.
ON / OFF Switch :
Power ON / OFF the transmitter.
FTN Key :
Is used to synchronize the connection between the transmitter and
the receiver. It also serves as additional function on different model.
LED Indicator :
Green and Red color for indicating battery low, pairing in
progress, End-Points setting and normal operation.
ATV :
Adjust the maximum steering angle on both sides when model turns
Left / Right.
ST. Trim Dial :
Adjust the neutral position of steering servo when model
wheels are straight ahead.
TH. Trim Dial :
To adjust the throttle position
Steering Reverse :
Reverse the response direction when operating Steering Wheel.
Throttle Reverse :
Reverse the response direction when operating Throttle Trigger.
1. Supplied with 4 x 1.5V AA
Batteries, radio can be
operated a few hours.
Installation: Remove the
battery compartment cover
as shown below.
Reversing
Throttle Limiter
Reversing is used to change the response direction of steering wheel and throttle
trigger. This Transmitter features 2 reversing functions: Steering Reverse and Throttle
Reverse.
Steering Reverse:
Reverse the response direction
when operating steering wheel. Turning left steering
wheel, the model turns right while turning right the
model turns left.
Throttle Reverse:
Reverse the response direction
when operating throttle trigger. Pushing forward
throttle trigger the model moves backward while
pulling back, the model moves forward. If necessary
you can just use a small screwdriver to adjust the
responding switches.
Installed the Throttle limiter can reduced
Throttle travel by 30% .
Ideal for beginner.
ATV enables to adjust the maximum steering angle of servo on both sides (Left
and Right) when model makes steering. The ATV affects the sensitivity of servo.
Reducing dual rate value can lower the sensitivity of servo and reduce the same
maximum steering angle on both sides. Remember to adjust the ATV within the
adjustment range.
ATV
ATV
ENG
