3
Z-CAR
CRX-170
Z-CAR
CRX-170
Z-CAR
CRX-170
Z-CAR
CRX-170
Z-CAR
CRX-170
Z-CAR
CRX-170
RECEIVER CONNECTION AND INSTALLATION
Z-CAR 2.4GHz Receiver CRX-170
Z-CAR 2.4GHz Receiver CRX-170 Synchronization
Remarks :
The mounting positions of receiver and
antenna cable greatly affect the operating
range.
Install the antenna vertically to the ground.
Auxiliary Port (Reserved)
Steering Port :
Where to plug in the servo.
Throttle Port :
Where to plug in the Electronic
Speed Controller (ESC).
Setup Button :
Synchronize transmitter and receiver.
Select frame rate.
Steering Port
Throttle Port
Auxiliary Port
(Reserved)
Warning :
• Never bend the metal pins on the
PCB of receiver.
• Never cut the antenna cable.
• Install the antenna vertically as
shown in the figure.
• Keep the antenna as far away from
the motor, ESC and other noise
sources as you possibly can.
Setup Button
Antenna Cable
CRX-170
Tips :
• Wrap the receiver with something soft, such as foam
rubber, to avoid vibration. If there is a chance of getting
wet, put the receiver in a waterproof bag or balloon.
MAKE SURE ALL CONNECTIONS ARE CONNECTED AND IN THE RIGHT ORDER
IF IT FAILS TO SYNC, THE LED WILL CONTINUE TO FLASH AND PLEASE GO BACK TO STEP 1 AGAIN.
1. Transmitter is
OFF
Position
3. The LED on the receiver will Flash
4. The flashing pattern on the receiver indicates the frame rate:
High Speed Flash
is for
all kind of Servos
and
Slow Speed Flashing
is for
Analogue Servos ONLY
2.
HOLD
the Setup Button located on
the Receiver while turning
ON
High Speed Flash
Slow Speed Flashing
5. Select the desire frame rate by
pushing the
Setup Botton
on the
receiver
ONCE
.
6. Now, take the transmitter
HOLD
the
FTN KEY
while you turn the
Transmitter
ON
Now the Transmitter is SYNCing
with the Receiver
7.When the LED on both Transmitter and the Receiver remain solid then
Transmitter is sucessfully Sync to Receiver
Z-CAR
CRX-170
