14
15
Alarm Level can be set for 1 to Span-Adjusted value or OFF.
・
Setting unit is 1 mg/l.
・
The Alarm Level is set for OFF as a factory setting.
Alarm Level Setting
Ex: To set the Alarm Level for 30 mg/l ;
4
Press to terminate the Alarm Level Setting.
3
Enter "30" on the Display.
2
1
Press for 2 seconds or more, the
Alarm Level Indicator blinks.
Press and select the Alarm Level.
Pip
Pip Pip
Move the digit to be entered using the right and left arrow buttons
(1 digit 10 digit 100 digit 1000 digit).
At this time, the selected digit blinks.
・
・
・
Reference
・
Enter a numerical value (0, 1, 2, ..., 9) into the selected digit using the
upper and lower arrow buttons . button increases a numeric
value and button decreases the value.
While pressing buttons, the values displayed are continuously
changed.
Reference:
・
To cut off the Alarm Relay Output, enter "0". Then "OFF"appears on the Display. Next,
press .
To cancel the Alarm Level Setting, press .
CAUTION:
・
When Err6 is displayed, the value is out of the setting range.
Alarm Timer can be set for 1 to 120 minutes or OFF.
・
Setting unit is 1 minute.
・
The Alarm Timer is set for OFF as a factory setting.
Alarm Timer Setting
Ex: To set the Alarm Timer for 60 minutes ;
3
Enter "60" on the Display.
2
1
Press for 2 seconds or more, the
Alarm Timer Indicator blinks.
Press and select the Alarm Timer.
Pip
Pip Pip
・
To change the Display for the Measurements Indication mode, press
again.
4
Press to terminate the Alarm Timer Setting.
Move the digit to be entered using the right and left arrow buttons
(1 digit 10 digit 100 digit).
At this time, the selected digit blinks.
・
・
・
Reference
・
Enter a numerical value (0, 1, 2, ..., 9) into the selected digit using the
upper and lower arrow buttons . button increases a numeric
value and button decreases the value.
While pressing buttons, the values displayed are continuously
changed.
Reference:
・
To cut off the Alarm Timer, enter "0". Then "OFF"appears on the Display. Next,
press .
To cancel the Alarm Timer Setting, press .
CAUTION:
・
When Err6 is displayed, the value is out of the setting range.
・
To change the Display for the Measurements Indication mode, press
again.
