Optal 4 Glass 2 burners, Installation & Operation Manual

Page: 6 / 166

6
MODELS
All the models referenced in this manual are equipped with the same basic equipment
including: firebox and leg supports, burner, gas valve, glass panels, operation control,
special tools, etc.
ALL the warnings and instructions apply to ALL the models.
WARNING
: Glass Handling
The glass must ONLY be removed by an authorized &/or qualified installer. The
authorized technician should ONLY remove the glass with the glass vacuum holders
supplied by the manufacturer. Lower the glass to rest in a safe place. This is to prevent
damage to the glass edges.
Step 1. Prepare a safe place for the glass to rest.
Step 2. Remove the glass using the vacuum holder.
Step 3. The glass can now be rested safely.
WARNING
: Electrical Grounding
These Direct Vent appliances must be electrically grounded in accordance with the
local codes or, in the absence of local codes, with National Electric code, ANSI/NFPA
70, or the Canadian Electric Code, CSA C22.1.
WARNING
: Gas Appliance
This appliance is only for use with the type of gas indicated on the rating plate. These
appliances are not convertible for use with other gases, unless a certified kit is used
and the conversion is performed by an authorized qualified technician.
Applicable standards are Vented Gas fireplace heaters ANSI Z21.88 / CSA 2.33a and
gas-fired appliances for use at high altitudes CAN/CGA 2.17-M91.
WARNING
: Installation and Service
Installation and service must be performed by an authorized qualified installer service agency or
gas supplier.
Any alteration to the product that causes soot or carbon to form and results in damage is not the
responsibility of the manufacturer.
In the case of models supplied with a door fitted in the frame of the heater, ONLY an
authorized qualified installer may open this door. The end user must NOT open the door, as this
may be unsafe and may result in voiding the manufacturer’s warranty.