Optal 4 Glass 2 burners, Installation & Operation Manual

Page: 136 / 166

21 / 65
© 20
11 Mertik Maxitrol GmbH & Co. KG,
All Rights Reserved.
EN
G
LIS
H
1. Place ON/OFF switch (if equipped) in O (OFF position).
2. If gas control is accessible turn main valve knob to
the OFF full clockwise position.
3. Replace appliance access cover (if applicable).
Figure 25: Combination control, cover
8 Wire
Receiver jack
Micro switch
MANUAL knob
in MAN position
Main valve knob
in OFF position
Manual pilot
valve operator
Piezo ignitor
(optional)
ON/OFF switch
(optional) in
ON Position
Connection
piezo ignitor
tab 2 8 x 0.8 mm
TO TURN OFF GAS TO APPLIANCE
AUTOMATIC TURN DOWN
AUTOMATIC SHUT OFF
Low Battery Receiver
▪ With low battery power in the receiver the system shuts
off
supply is interrupted.
Five Day Shut Off
(CSA version)
▪ The system
Second Thermocouple Shut Off
▪ Second Thermocouple Option: The system shuts off
approximately 20 seconds after ignition or after push-
ing the
NOTE: Before the next ignition there is a 2 minute wait-
ing period.
OPERATING INSTRUCTIONS FOR OEM USE ONLY
6 Hour no Communication Function
(CSA version)
▪ Manual Mode/Temperature/Timer Mode: The valve will
for a 6 hour period. In Temperature/Timer Mode if the
will adjust automatically to maintain set temperature,
ambient room temperature remain the same over a
6 hour period.
Receiver Overheating
(only if module is connected)
▪ Valve -
ceiver is higher than 140 °F (60 °C). The main burner
comes back on only when the temperature is below
140 °F (60 °C).
1 Hour Turn Down for Special Receiver
▪ The valve
APPENDIX B
A p p e n d i x B