Optal 4 Glass 2 burners, Installation & Operation Manual

Page: 130 / 166

15 / 65
© 20
11 Mertik Maxitrol GmbH & Co. KG,
All Rights Reserved.
EN
G
LIS
H
NOTICE
NOTICE
NOTICE
NOTICE
Replacement handsets for CSA models also must
have the same part number (see label).
GENERAL NOTES
Wiring of valve and receiver must be completed be-
fore starting ignition. Failure to do so could damage
the electronics.
Radio Frequency Handset
433.92 MHz for Europe; 315 MHz for U.S. (FCC ID:
RTD-G6R) and for Canada (IC: 4943A-G6R).
This device complies with part 15 of the FCC Rules. Op-
eration is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This
device must accept any interference received, includ-
ing interference that may cause undesired operation.
party responsible for compliance could void the user’s
authority to operate the equipment.
Figure 22: Receiver Reset Button
(First time use only.)
Radio Frequency Handset
A code is selected automatically for all Mertik Maxitrol
electronics from among 65,000 random codes available.
The receiver has to learn the code of the handset:
▪ Press
and the second beep is long. After the second beep,
release the reset button.
▪ Within the subsequent 20 seconds press the (small
-
hear one long beep, this indicates the code learning
sequence has failed or the wiring is incorrect.
NOTE: This is a one time setting only, and is not re-
quired after changing the batteries of the hand-
set or receiver.
Batteries – Handset:
▪ 1 x 9V (quality alkaline recommended).
▪ Low battery indicator on handsets with display.
▪ Handsets without display: the red LED gets darker.
▪ Battery replacement is recommended after 2 years.
Batteries – Receiver:
▪ 4 x 1.5V “AA” (quality alkaline recommended).
▪ Low battery indication: frequent beeps for 3 seconds
when motor turns.
▪ An AC Mains Adapter may be used instead of batteries.
▪ The module for fan speed control and light/dimmer in-
cludes mains power together with batteries in the re-
ceiver for automatic backup in case of power outage.
▪ Without using a mains adapter, battery replacement is
recommended at the beginning of each heating season.
Only the Mertik Maxitrol AC Mains Adapter or one
preapproved by Mertik Maxitrol can be used. Use of
other adaptors can render the system inoperable.
OPERATING INSTRUCTIONS FOR OEM USE ONLY
Figure 21: Previous Handset
The handsets, receivers, wall switches, switch panels
and touch pads are not interchangeable with previ-
SETTING THE ELECTRONICS CODE
Light/Dimmer operation (page 17)
Fan operation (page 17)
Time setting (page 18)
Program timer setting (page 19)
Temperature setting (page 19)
°C/24 hour or °F/12 hour Clock
setting (page 18)
Fan level icon (page 17)
Solenoid Valve/Burner
OPEN and CLOSE (page 17)
ON/OFF Temperatures setting (page 19)
Battery status
Signal indicator
Modes of operation (page 18)
Figure 20
APPENDIX B
A p p e n d i x B