Optal 4 Glass 2 burners, Installation & Operation Manual

Page: 160 / 166

APPENDIX E
11 | A p p e n d i x E
Appendix A
Handling Glass
1. Demonstration
Sketch A
2. Install / Re-Install
a. When installing, install glass
base first and then top.
b. Must use vacuum holder and
secure by using blanket.
c. When closing screw of the
glass trim, close gently with
finger force
(No need to tighten)
until it’s closed.
d. When installing the glass
back, make sure that bottom
trim screws are a little bit
loose, verify that the glass is
lining on the bottom trim and
not on the screw.
e. Always close bottom glass trim
first (don’t tighten yet) and
then top. (Verify that the trim
site is at the right place, levelled and not in an offset position).
f. When you tighten the screw with
g. Use glass vacuum holder, 10mm key and make sure to secure glass when
it is out of the fireplace.
finger force, you must do it from side to
side (not from the middle to the sides).
h. Please see figure 12A and 12B
3. Remove
a. When removing glass, always release top glass trim and then bottom.
b. Use glass vacuum holder, 10mm key and make sure to secure glass when
it is out of the fireplace
c. Please see Sketch A
4. Clean
1. Demonstration
Silicon
2. Application and Removal
3. Cure Time 24 hours and Operation Following Installation
4. Dry silicon method
Special wooden
supports or blanket(s)
Glass
Vacuum glass
holders
Keep anti slip angle