Programming
Display Screens
#1 & 2
Selections are:
DSP1L1
Display 1, Line 1
DSP1L2
Display 1, Line 2
DSP2L1
Display 2, Line 1
DSP2L2
Display 2, Line 2
To Program Display Screens #1 & 2:
From the Main Menu press
DSP (F3)
to select the display menu:
F1 F2 F3 F4
Press
DSP (F1)
key. The display will show:
F1 F2 F3 F4
These are the selections for the display #1 line #1.
Selections are:
Flo rate
Flow rate
Total
Total mass or volume
Elps
Elapsed time
Temp
Temperature
Alarm
Error codes
When the selection is correct, press
OK (F4)
to accept. The display will then go
through the same process for all 4 lines of the 2 programmable displays (DSP1L1,
DSP1L2, DSP2L1 and DSP2L2).
After the last line of display 2 is accepted, the display will show the following menu:
F1 F2 F3 F4
This menu allows you to alternate between menu display 1 and 2 every few seconds.
Selections are: On or Off
Press
OK (F4)
to accept selection. Press
EXIT (F4)
repeatedly until “Normal Mode” is
seen briefly to exit the programming mode.
11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax +1 (727) 442-5699 • [email protected]
F-5500 Thermal Mass Flow Meter Manual 06/17 - 2030 / 107023
Page 47
Model F-5500
OPERA
TION
Operation: Programming
Programming
by Display
DISPLAY/PASSWORD
DSP PSW EXIT
DSP1L1 = Flo rate
NXT OK
ALTERNATE = Off
NXT OK
