Omron WE70-AP, Operation Manual

Page: 31 / 146

1-11
Chapter 1. Overview
1
Overview
■
Rear View
[For Reference]
• Use a Crossed LAN cable for a connection between a wireless unit and a hub.
• The [LAN] port of a wireless unit does not support automatic detection of straight LAN cable or cross
LAN cable. Be careful for polarity to connect to a hub that does not support the automatic detection.
[LAN] indicator will not be lit if polarity is wrong.
• For 100BASE-TX communication, STP LAN cable of category 5 or higher must be used. If a cable with
lower category is used for the same LAN, total cable characteristics will be degraded to the lowest level
of such a cable.
WE70-AP
WE70-CL
ETHERNET
INIT
PUSH
RSSI
ETHERNET
INIT
+ –
24V
+ –
24V
<INIT> Button
Initializes setup.
* Use a pen tip to press.
"6-2. Restoring to Factory Shipment Status"
(See P.6-5)
DC Connector
Supplies 24VDC power.
RSSI Button
Switches receiving status
indication.
Flashing in 4 levels [LAN] Port (RJ-45 x 1)
Connects a network device
such as a hub through a LAN
cable.
Antenna Connector
Used to connect accessory antennas.
* To ensure performance, always connect
both of 2 antennas.