7
V400-R1CF/R1CS
User’s Manual
Int
rod
uct
ion
Introduction
Observe the following precautions to ensure safe use of the product.
1. Installation Environment
•
Do not use the product in environments containing flammable or explosive gases.
•
Do not use the product in environments containing corrosive or combustible gases.
•
Do not use the product in environments containing dust, salt, or metallic powders.
•
Do not use the product in environments containing droplets, water or mist, oil or
chemical agents.
•
Do not use the product in environments that may be affected by a CRT's flashing or
other ambient light.
•
Do not install or use the product outdoors.
•
For the purpose of ensuring safe operation and maintenance, do not install the
product close to high-voltage devices or electrically powered devices.
2. Power Supply and Wiring
•
To assure noise and insulation resistance, be sure to use S8VS-01505 (made by
OMRON) as a driving power supply.
•
Do not connect a voltage or AC power supply that has a voltage exceeding the rating
voltage (5 V+/-10%).
•
Avoid reverse connection of power supply. Do not short circuit a load on OK/NG
output signal (open collector).
•
Avoid applying a load that exceeds the rating.
•
Be sure to turn the power OFF before connecting or disconnecting a cable.
Connecting or disconnecting a cable while the power is ON may cause failure.
•
Connect different cables from high-voltage or power cables to the product. If the
same cable or duct is used, electromagnetic induction may result, which may result in
malfunction or damage.
•
Tighten the fixing screws at the torque specified in this manual.
3. Communication with Upper Equipment
•
Check that the product has started up, and then start communication with upper
equipment.
•
Indefinite signals may be generated from the upper interface while the product starts
up. Clear the receive buffer of the devices before starting initial operation.
Precautions for Safe Use