![background image](http://html.mh-extra.com/html/omron/sysmac-cpm2b/sysmac-cpm2b_operation-manual_1633427029.webp)
11
System Configurations
Section 1-2
1-2-4
Connecting a Programming Console
A Programming Console can be connected to the CPM2B CPU Board’s
peripheral port, as shown below.
Note
1.
Always turn OFF SW 201 before connecting the Programming Console.
2.
Only the peripheral port connector can be used when a CPM2C-CN111
Connecting Cable is connected.
1-2-5
Support Software
A personal computer running the CX-Programmer (version 1.2 or later) or the
SSS can be connected to the CPU Board’s Peripheral port or RS-232C port.
Refer to 1-2-6 One-to-one Computer Connections for details on the computer
connection.
Always turn ON Communications Switch SW201 when using Support Soft-
ware instead of a Programming Console. The setting on Communications
Switch SW202 determines whether the communications settings in the PLC
Setup or the standard settings will be used, as shown in the following table.
Peripheral port
CPM2C-CN111
Connecting Cable
(0.1 m) (See note 2.)
CS1W-CN114
Connecting Cable
(0.05 m)
CQM1-PRO01-E
CS1W-CN224 (2 m) or
CS1W-CN624 (4 m)
Connecting Cable
CPM2B CPU Board
C200H-PRO27-E
C200H-CN222 (2 m) or
C200H-CN422 (4 m)
Connecting Cable
Attached
cable (2 m)
Peripheral port
connector
SW201
(See note 1.)
CQM1H-PRO01-E
Cable (2 m)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com