Inspecting with the Search Inspection Item
FQ Short Manual
4
Settin
g Up In
spections
37
Step 2
Teaching
Teaching means to store the region and partial image as reference data for the measurement.
[Inspect]
−
[Add item.]
−
[Search]
−
[Settings] Tab Page
The following data is stored as the measurement reference.
Step 3
Adjusting Judgement Parameters
[Inspect]
−
[Add item.]
−
[Search]
−
[Settings] Tab Page
1
Press [Teach].
2
Place the object that is to be used as the measure-
ment reference in front of the camera.
3
Move the rectangle to the location to be measured.
4
Press [OK].
5
Press [TEACH] on the lower right of the display.
The basic settings will be registered when teaching has
been completed.
6
Press [Back] to end teaching.
Item
Parameter
Description
Reference data
Model image
This is the partial image that is stored as the reference.
Reference position X
These are coordinates of the model image that are stored as reference.
Reference position Y
1
Press [Judgement].
2
Set the correlation range for an OK judgement.
Continuous measurements will be performed for the im-
ages that are taken.
3
Press [OK] to accept the value.
4
Press [Back] to end making the setting.
Parameter
Setting
Description
Correlation
Range: 0 to 100
Default: Lower limit: 60, Upper limit: 100
Adjust the upper and lower limits of the correlation for an OK judge-
ment.
Drag a corner to
size the rectangle.
Drag the rectangle
to move it.
Blue for OK. Red for NG.
Lower limit Upper limit