Inspecting with the Area Inspection Item
FQ Short Manual
4
Settin
g Up In
spections
43
Step 2
Teaching
Teaching means to store the region and the color area in the region as reference data for the measurement.
[Inspect]
−
[Add item.]
−
[Area]
−
[Settings] Tab Page
The following data is stored as the measurement reference.
Step 3
Adjusting Judgement Parameters
[Inspect]
−
[Add item.]
−
[Area]
−
[Settings] Tab Page
1
Press [Teach].
2
Place the object that is to be used as the measure-
ment reference in front of the camera.
3
Move the rectangle to the location to be measured.
4
Press [OK].
5
Press [TEACH] on the lower right of the display.
The basic settings will be registered when teaching has
been completed.
6
Press [Back] to end teaching.
Item
Parameter
Description
Reference data
Extract color
If the extract color has not been set, the target color will be automatically
extracted.
Reference area
The area to use as a reference is set automatically.
1
Press [Judgement].
2
Set the D. Area range for an OK judgement.
Continuous measurements will be performed for the im-
ages that are displayed.
3
Press [OK] to enter the value.
Item
Parameter
Setting
Description
Judgement Parameter
D. Area
Range:
−
360,960 to 360,960
Default: Lower limit:
−
360,960, Upper
limit: 360,960
Set the upper and lower limits for an OK
judgement. The set range is the differ-
ence between the reference area and
the measured areas.
Drag a corner to
size the rectangle.
Drag the rectangle
to move it.
Blue for OK. Red for NG.
Lower limit
Upper limit