18
Basic Operating Procedures
Section 1-4
1-4
Basic Operating Procedures
1-4-1
DeviceNet Network Configuration and Wiring
1,2,3...
1.
Determine the Baud Rate Required for the Application
Refer to the section on communications timing in the Master Unit Manual
(see below) to determine the appropriate responsiveness and baud rate for
your application.
• CS/CJ Series DeviceNet Operation Manual (W380)
• CVM1/CV DeviceNet Master Unit,
C200HX/HG/HE DeviceNet Master Unit Operation Manual (W379)
• DeviceNet PCI Board Operation Manual (W381)
2.
Determine the Cable Layout and Cable Lengths to All Nodes
Verify that the planned configuration is within the network configuration
specifications.
• Refer to
2-1 Network Configuration Overview
for details on the network
configuration.
• Refer to
2-2 Network Configuration
for configuration precautions.
3.
Determine the Communications Power Supply Method
When planning the communications power supply layout, verify that the
voltage drop over the communications cables is within specifications.
• Refer to
SECTION 3 Communications Power Supply Methods
for de-
tails.
• In particular, refer to
3-2-1 Communications Power Supply
for a flow-
chart that will guide you through the selection process.
4.
Select the Required Devices
• Refer to the device manuals when making arrangements for the Mas-
ters, Slaves, and the Configurator.
• Refer to
2-3 Cables, Connectors, and Related Devices
for details on
other related devices.
5.
Purchase the Required Equipment
6.
Construct the Network
Construct the network using recommended wiring and noise-control tech-
niques.
• Refer to
2-4 Wiring Methods
for details on wiring.
• Refer to
2-5 Minimizing Noise in the Network
for details on noise-con-
trol techniques.
• Refer to
2-2 Network Configuration the Network Configuration
for other
precautions.
1-4-2
Network Start-up Procedure
Turn ON the communications power supply.
Turn ON the Slave power supply.
Turn ON the PLC (Master Unit) power supply.
Operate the network.
Summary of Contents for DEVICENET -
