Omron BA100R, Instruction Manual, Page: 45 / 104

3 Check and start operation
3-3 Start and stop procedures and basic operation
3-3 Start and stop procedures and basic operation
3-3-1 Start and stop procedures
For cautions when operating the UPS, including start and stop, refer to “Caution (for use)”
shown in the “Safety precautions” of the beginning of this manual.
■ Start procedure
Turn on the “Power” switch of the UPS.
・ Output begins in Inverter Operation a few seconds after the switch is activated.
(Status indicator “ “)
・ The status indicator displays “ “, and the self-diagnostic test is performed in
Battery Mode for about 10 seconds. (If the battery voltage is low, the
self-diagnostic test is not performed. It is automatically executed after the battery
is charged.) When the self-diagnostic test finishes successfully, switching to AC
output from commercial power is performed and normal operation starts.
・ When the self-diagnosis test finishes normally, the unit enters the normal
operating state through inverter operation.
・ When the self-diagnostic test is not performed, AC output begins immediately
inverter operation.
・ During operation, the battery is charged automatically.
AC input
7 seg.
Power supply SW
Power supply
output lamp
Operating mode
Output
ON
OFF
ON
OFF
ON
OFF
Commercial
Power Battery
Commercial
Power Battery
<Note>
D-1: Display the latest UPS fault mode
(If there is no record for UPS fault, UPS display the
Startup
preparation
a few
seconds
Bypass
operation
a few
seconds
Self-diagnostic
test
about
15 sec.
Inverter
operation
D-1
1 sec.
Status indicator
Beep None
Power supply output receptacles Outputs power (connected devices are powered)
BA75T/BA100T/BA100R
44