Omron A2W-R**-WC1 Series, User Manual

Page: 76 / 96

6 Wireless Test in the TEST Mode
6 - 2 Wireless Pushbutton Switch User’s Manual (A265)
6-1 Wireless Test
This section describes the wireless test procedure of the wireless pushbutton switches system.
In TEST mode, you can perform a wireless test.
In TEST mode, the Master Unit does not output even when receiving an operation signal from the Slave
buttons. TEST mode is used for installation environment test such as reception strength measurement.
Do not execute the wireless test at the same time for multiple Master Units in TEST mode. Be sure to
perform the test for each Master Unit. If wireless test for two or more Master Units in TEST mode are
executed at the same time, they may be influenced by each other's radio and may not obtain the correct
result.
 Operation Procedure Flowchart
Weak
Sending and
receiving successful
Received field strength
Transmission
failure
Sending and
receiving successful
Received field strength
Received field strength Received field strength
The test result.
Strong
Weak Strong
< Master Unit > < Slave buttons >
1. Set the mode
settings switch
to "TEST".
Test start
2. Press the pushbut-
ton of the Slave
button you want to
test.
3. Reception
confirmation LED
is lit.
4. The output LED
(example: OUTPUT 1)
lights in yellow.
5. The RCV LED is
turned.
Lit yellow
Lit green
Lit green
Lit yellow
Lit red