omi ESD 1300, Instruction And Maintenance Manual

Page: 21 / 122

Cod. 710.0159.01.00 Rev0A – 10.2011
17 - 275
Electronic drain discharge is the new discharger applicable
to any compressed air systems. It eliminates the
condensate without wasting compressed air.
Electronic drain discharge starts automatically, without the
need of any adjustment. The condensate discharge occurs
to the use of an electronic sensor, which detects the
amount of condensate in the integrated water collecting
tank. The level sensor drives start and duration of the
drainage, so preventing any wasting of compressed air.
At the end of installation, put the system under pressure
and push the TEST key repeatedly to eliminate the air
bubbles contained in the discharger inlet fittings.
To this discharger will be applied the Beko warranty
conditions.
The electronic drain discharge is supplied completely
with an output configured as remote signalling alarm.
Proceed as follows to activate a remote alarm
output:
1.The User must provide a signaller in compliance to
output relay electrical features (solenoid coil, light
bulb, acoustic signaller, ...).
2. Disconnect the dryer from electrical feeding and
open the electrical box.
3. Connect the signaller on “BEKO DISCHARGER
ALARM” terminal blocks (See electric wiring
diagram).
Alarm Output relays electric features:
Voltage <250Vac
max. current <1,0A
Activation of the above function is on User’s discretion. The User will purchase all necessary
installation material by himself. Any operation which needs access to the dryer must be carried out
by qualified personnel.
8.3 Maintenance and malfunctioning treatment
Should the discharger not operate correctly, try to act on the TEST key to clean the mesh
filter.
Never remove the discharger body. Should the malfunctioning persist, contact our Customer
Service.
9.0 DECOMMISSIONING
In case of necessity, decommission the machine and the relevant packaging in compliance with the
rules locally in force.
Pay particular attention to the refrigerant, as it contains part of the refrigerating compressor lubricating
oil.
Always contact a waste disposal and recycling facility.