CONNECTION:
Connect the Green wire to the host keyless entry unit's "lock" output
wire, and the Blue wire to the "unlock" output wire; these connections are best made at the
host keyless entry receiver unit. This method requires that the lock and unlock input pulses
be Negative; where needed, relays may be used to reverse the polarity. Check to ensure that
at the chosen connection location that operating the doorlock switches does not cause
Negative pulses to backfeed to the keyless entry receiver. If so, diodes may used to isolate
the switches from the keyless entry receiver so that the RS-6 is only activated from the
receiver, and not the switches.
Ground
Lock
Unlock
+
+
Doorlock
Actuators
Vehicle's Doorlock
Relay Control Unit
Doorlock
Switch
Lock
Unlock
Vehicle's Keyless
Entry Receiver Unit
2-Pin Plug Green Wire
2-Pin Plug Blue Wire
RS-6
2-Pin
Blue Plug
Note: if the car's switches backfeed
to the receiver, add diodes here
Summary of Contents for RS-6
Page 27: ......
