OMEGA AIR A-DRY Series, Installation And Operating Manual, Page: 29 / 65

29
There are two possible modes of entering standby. It the Finish Cycle mode, dryer completes
regeneration and prepare columns for new cycle. Only after that it enters stand by.
On the other hand, in the Direct Stop mode the dryer freeze regeneration. Thus, air
consumption for regeneration is stopped immediately. After the input signal is set again, the
dryer continues adsorption and regeneration. If a column is already regenerated and it is
idling, then the dryer completes the cycle before it enters stand by.
5.13 Statistics
This menu gives us some information about dryer.
In case of the service or repair is needed, these two menus are helpful and should be
provided to manufacturer.
2 sec.
**** Input/Output ****
Set Standby Mode:
>Mode: Finish Cycle
**** Input/Output ****
Set Standby Mode:
Mode: >Finish Cycle
**** Input/Output ****
Set Standby Mode:
Mode: >Direct Stop
◄ STANDBY >
00:00 00:00