24
24
3-2 Main switch
Rotate the light intensity knob a counterclockwise fully and set the
main switch b to (ON).
In case of emergency, disconnect the power cord from
the product , and set the main switch to (OFF) to shut
down the power supply. Do not place any object near the
main switch so that the main switch operation will not be
interfered.
· When the power is turned ON, the buzzer sound is heard
once. The buzzer sound can be set to silent by setting the DIP
switches. For setting procedures, see “Setting the DIP switch /
AS.PRESET switch" (P.98).
· After the power is turned ON, the aperture diaphragm starts
initializing and the aperture diaphragm open/close button on
the front panel blinks for several seconds.
If following units are combined, set the main switch of the respective
unit to (ON).
Combinable units
Unit to set to ON
Mercury lamp housing
Main switch of the power supply for
mercury burner (U-RFL-T)*
Halogen lamp housing
Main switch of the power supply for
halogen bulb (TH4-100/TH4-200)
Light source
Main switch of the light source
(U-HGLGPS)
LED light source for light
guide
Main switch of the LED light source
for light guide (LG-LSLED)**
* In general, the arc image becomes stable 5 to 10 minutes after
turning ON the power supply, but the discharge type mercury burner
may not turn ON by one operation due to its nature. In this case,
set the main switch to (OFF) once, wait 5 to 10 seconds and set
it to (ON) again.
** Name and detail specifications of this product might differ in Europe,
Middle East and Africa.
For details, refer to the instruction manual provided
with the respective unit.
1
CAUTION
TIP
2
b
a
Summary of Contents for MX63
Page 15: ...9 MX63 MX63L 9 MX63L installation space Unit mm ...
Page 27: ...21 MX63 MX63L 21 Memo ...
Page 119: ......