39
CKX53
2
Attaching the mechanical stage CKX3-MVR
When using the mechanical stage CKX3-MVR, we
recommend you to use it in combination with the sub stage
CK2-SS to exhibit its full performance
Attaching the frame portion
Attaching the mechanical stage CKX3-MVR to the plain stage allows you
to move the container on the stage using the knob of the mechanical
stage.
Tighten the attaching knobs (2 pcs.) to secure the mechanical stage
frame portion at the bottom of the right side surface of the plain stage.
Attaching the holder portion
Push the one side a of the holder portion to the rotation portion b
of the mechanical stage CKX3-MVR.
Match the other side c of the holder portion with the rotation portion
d of the mechanical stage, and combine them with the knob screw
e .
TIP
11
12
13
e
d
a
c
b
1
· For objectives provided with each set, see page 29.
· For specifications of objectives including options, see page 30.
· It is recommended to attach the objectives as shown in the
picture where the revolving nosepiece is viewed from above.
Remove the stage center plate and attach the objectives to the
revolving nosepiece.
Rotate the revolving nosepiece counterclockwise (arrow
direction) with the left hand, and attach the objectives in the
order from the lower magnification to the higher magnification
to place the objectives at recommended positions.
In the inverted microscope, since front lenses of
objectives face upward, dust or dirt may easily be
attached to lenses. Attach the caps to screw holes
a
of
the revolving nosepiece where no objectives are attached.
After all objectives are attached, fit the stage center plate into the stage.
When removing the objectives, follow the procedures opposite
to those of attaching.
TIP
1
TIP
NOTE
2
TIP
7-5 Attaching the objectives
4X
10X
20X
40X
a
