26
Fig. 35
Fig. 36
Fig. 37
With the WI-UCD Condenser (Figs. 35 - 37)
}When selecting the brightfield (BF) light path using the WI-UCD, leave
one DIC prism (large) mount position empty.
1. Remove the WI-UCD condenser from the microscope frame.
2. Remove the condenser cover
1
by loosening the retaining screws
2
using a coin, etc.
3. Attach the suitable DIC prism for the objective in use as described below.
· Using the dedicated knob provided with the condenser, loosen the two
DIC prism clamping screws
3
until the rotatable limits.
· Rotate the turret by 90° counterclockwise, and drop in the DIC prism by
aligning its positioning pin
5
with the positioning groove
6
in the hole of
the turret
4
(Fig. 36).
# Be careful not to touch the prism inside the frame.
A. Rotate the turret
4
by 90° clockwise (Fig. 37) and tighten the two DIC
prism clamping screws
3
uniformly using the dedicated knob provided
with the condenser. (Figs. 36 & 37)
# Do not tighten the screws too much, or the prism frame may be
deformed.
B. Rotate the turret
4
by 90° clockwise (Fig. 37), and attach the index sticker
7
provided with the DIC prism onto the side
8
of the condenser turret
4
so that the index sticker is upside down. (Figs. 36 & 37)
4. After attaching all of the required DIC prisms, attach the cover
1
and
tighten the retaining screws
2
. (Fig. 35)
5. Attach the condenser back onto the microscope frame.
1
2
3
5
6
7
8
4
A
B