44.
Repeat
Steps 38 - 43
to complete opposite side of Roof Section.
45.
Locate 4
Metal Roof Panels
and 4
Metal Roof Hangars
. To
temporarily hold the
Metal Roof Panels
in place, hook a
Metal Roof
Hangar
onto the lowest
Batten
, approximatley where the center of the
panels will be. Place first
Metal Roof Panel
on Battens and into Hangar.
Do not fasten panels down until
Step 48
. Place remaining 3 panels and
hangars on the same way.
Metal Roof Panels
will overlap eachother.
46.
Overhang the
Metal Roof Panels
past the
Battens
on sides of Shed. Adjust panels side-to-side to
achieve desired width. Overall width past the
Battens
can vary from 1” - 3” depending on your
preference. The overhang over the front & rear of your shed will be set by the
Metal Roof Hangars
,
approximatley 4”.
Parts (Steps 45 - 50)
Metal Roof Panels
(50” long)
x 8
Hardware (Step 45)
Y38 - Metal Roof Hangars
x 4
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 24
