Front Top Plate
Flashing overhangs
wall on outside.
Use a straight edge to check
that angle of Gable lines up
with Top Plate angle. Adjust
Gable for best fit.
24.
Align and attach opposite Side Gable Wall
as per
Step 23.
Flashing will overhang Wall on
outside.
22.
Next, attach the
Front Top Plates
. The Front and
Rear Top Plates are angle cut down the length. Once
again, position Top Plates on wall frame so they are flush.
Front and Rear Top Plates will fit between Side Top Plates.
Attach with
4 - 2” Screws
per plate. Complete all other
Side
&
Rear Top Plate
attachments.
23.
Place
Side Gable Wall
so 1x3 framing sits flush with the inside
of the Top Plate. It should also be centered sideways on the Top Plate.
Adjust Gable accordingly. Temporarily attach to Walls and Top Plate
with
2 - 2” Screws
. Gables may need slight adjustment in
Step 43
when
attachment will be completed with an additional 6 Screws.
Screw from the bottom of Gable framing down into Top Plate and
Wall.
Hint:
Use a straight edge to check the angle of the Gable fram-
ing and Top Plate. Both angles should line up (see diagram below).
Parts (Steps 23 - 24)
Side Gable Walls x 2
Hardware (Steps 23 - 24)
S3
- 2” Screws
x 4 total
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 16
