19
If the remote party called to talk only to you, at the
end of the conversation:
If your telephone installation has several sock-
ets and the connected telephone is not near the fax
machine, you can enable the latter for remote re-
ception, as long as the telephone works with tone
dialling (multifrequency):
•
Connect to the line by lifting the telephone re-
ceiver.
•
Press the * key on the telephone, followed by
the remote control code. Remember that the
code digit must be the one you have already
programmed (see "Changing the remote con-
trol code” chapter "For a more sophisticated
use").
Automatic reception ...
The fax receives the documents automatically without
any intervention.
The fax machine is already programmed to receive the
documents in automatic mode. Otherwise, press the
RX MODE key until “AUTOMATIC RX” is displayed.
The reception procedure is explained in the previous
section (Manual reception).
Automatic reception with call type recogni-
tion ...
You have programmed the fax machine, by pressing
the RX MODE key, to receive with this mode (“PHONE/
FAX RX” has to be displayed).
The behaviour of the fax in this reception mode will
depend on the caller. The procedure is illustrated in the
following diagram:
(*) You can modify both ring number and volume,
as well as the duration of the buzzer emitted by
the fax machine.
A FAX MACHINE is
calling
Your fax machine is
set to receive auto-
matically.
The remote par ty
called just to talk to
you: at the end of the
conversation, replace
the receiver.
Your fax machine
beeps for 20 sec-
onds (*). The display
shows "LIFT HAND-
SET".
A TELEPHONE is
calling
After ringing
twice (*)
20 seconds have
passed and you have
not lifted the receiver.
Your fax is set to re-
ceive automaticaly. It
will wait to receive a
document for about
30 seconds, then it
will return to the initial
waiting mode.
The remote party asks
you to receive.
Your fax is set to re-
ceive.
PHONE/FAX RX enabled
-3-10-27.p65
25/02/00, 9.16
19
