5699-E P-66
SECTION 4 INSPECTION, MAINTENANCE AND ADJUSTMENTS
9-2.
Changing the V Belt
Procedure :
1-
Follow the steps
“1-”
to
“3-”
described in 9-1. “Adjusting the Belt Tension.”
2-
Change the belts.
3-
Gradually tighten the adjusting bolt (described on the previous page) and mark up a point to
where slackness of belt is run out.
4-
Follows the steps
“5-”
and
“6-”
described in 9-1. “Adjusting the Belt Tension.”
10.
Replacing the Leaf Chain
Leaf chain extends because of wear of pin or bush. Check the chain extension in the periodical
inspection (every six months), and if the measured dimension is over the allowable dimension,
change the leaf chain. (See the table below.)
Changing Reference
Measurement Point
LE11214R0100600230001
CAUTION
Allowable dimension
6-link
157 mm (6.18 in.)
10-link
261.6 mm (10.299 in.)
Perform the replacement work with minding your steps as the leaf chain is located above
the column. Turn the power (NFB) off during the measurement.
Roller
Measure dimension
L1: Inner distance between the rollers
L2: Outer distance between the rollers
