Assembly & Preparation
29
5.2
Telescopic Rod Assembly
Depending on the task you want to fulfill, you have to attach one of your measuring probes to the probe
mount of your telescopic rod assembly. Figure 5.2 shows this process exemplary for the Telescopic
Probe.
Please pay attention that each measuring probe can only be attached in “one” way or direction
according to the frame on top of the probe mount. The little notch of the frame has to match the bump of
the probe mount.
Now you have to place another fully charged Power Pack into the designated slot of the eXp 6000
telescopic rod assembly as shown in figure 5.3.
Push it into the slot completely until it has locked. Then push the power on/off button on the front panel
of the Power Pack until the LED lights up.
OKM GmbH
www.okmmetaldetectors.com
Figure 5.3: Placing the Power Pack into the telescopic rod assembly
Figure 5.2: Mounting the Telescopic Probe onto the telescopic rod assembly
This notch ...
… has to match
this bump.
Summary of Contents for eXp 6000
