OKIDATA Pacemark 3410, Service Manual

Page: 83 / 249

Page: 51
Service Guide PM3410
Chapter 3 Maintenance & Disassembly
3.2.17 Paper Pressure Guide
1. Remove the platen assembly
(3.2.16)
2. Remove the two paper chute springs (1) located on each side of the paper pressure guide (2).
3. Remove the screw (3), located on the left side frame of the printer mechanism, directly under the upper
tractor shaft.
4. Remove the release lever detent spring (4) located on the right side frame of the printer mechanism.
5. Separate the claws and remove the release lever (5).
6. Remove the paper pressure bar (6) by sliding it to the right.
7. Using needle-nose pliers, squeeze the nylon latch (7) to release the paper out sensor wire harness (8).
8. Detach the cable from CN1 of the sensor board (9).
9. Lift the paper pressure guide and remove it.
P/N 50907502 Spring: (Paper Chute) RSPL B.2.06
P/N 50910201 Spring: Detent (Release Lever) RSPL B.2.06
P/N 53478706 Lever: Release RSPL B.2.06
P/N 53478801 Block: Release Lever Guide RSPL B.2.06
P/N 56625001 Cable: Cut Sheet Sensor Assembly RSPL B.2.06