Oki OkiLAN 6120e, User Manual

Page: 127 / 222

IV - 33
Section 4 - Chapter 4 - OkiNet for TCP/IP
OKI OkiLAN 6120e User’s Guide
TCP/IP
Trap Destination
• TCP/IP Protocol - Enter the IP address to which
traps will be sent. The IP address must follow the
format XXX.XXX.XXX.XXX, where each XXX is
a number from 0 to 255. To broadcast traps to all
hosts on the local subnet, enter 255.255.255.255.
• NetWare Protocol - Enter the network number and
hardware address, respectively, to which traps will
be sent. To broadcast traps to all addresses on all
networks, enter FFFFFFFF (8 characters) in the first
field and FFFFFFFFFFFF (12 characters) in the
second field. To broadcast traps to all addresses on a
specific network, enter the network number in the
first field and then FFFFFFFFFFFF (12 characters)
in the second field.
Ports to Trap
Select the output ports on which you wish traps to be
active.
Printer Traps
Select the printer traps to be activated. The following
printer error conditions may cause a printer trap to
occur:
• On-line
• Off-line
• No Printer Attached
• Paper Out
• Paper Jam
• Door Open
• Toner Low
• Printer Error
The toner low, door open and paper jam traps require
that your printer be set to automatic emulation
switching (the default) or PCL emulation.