Oki OkiLAN 6120e, User Manual

Page: 160 / 222

IV - 66
Section 4 - Appendix B - Application Considerations
OKI OkiLAN 6120e User’s Guide
6. Enable the printer you just created using SAM.
Peripheral Devices ->
Printers and Plotters ->
Enable a Printer ...
7. Printer name: — lj4
8. Start the LP request scheduler by typing:
/usr/lib/lpsched
9. Run a test print job to the OkiLAN 6120e with the
following command:
lp -d lj4 filename
Configuring HP-UX v9.xx for Printing
with the OkiLAN 6120e
This application note describes the configuration of the
printing system on the HP-UX ver. 9.xx of the UNIX
operating system. For clarity and brevity, the following
specific names will be used to represent general
devices or concepts.
• lj4 - The local queue name on the HP-UX system
to which print jobs will be directed. The print jobs
are destined for a printer attached to the OkiLAN
6120e.
• OKIPRINTER - The host name of the remote
system which is the OkiLAN 6120e. For example,
to telnet to the OkiLAN 6120e and invoke the
OkiLAN 6120e Configuration utility, you would
type telnet OKIPRINTER. A host name is not
required for the OkiLAN 6120e, the IP Address
may be used.
• yourqueuename - This is the name of the queue
on the OkiLAN 6120e and must end with 1, 2, 3
or 4, depending on the port selected to service the
print jobs.
If FF, LF or NF are the last two letters of the
queue name, the job will be converted
accordingly. See pages IV-15 and IV-16 for more
information on Remote Queue Names.