Oki OKIFAX OF5900, Maintenance Manual

Page: 131 / 472

OKIFAX 5700/5900 2 - 41
No. Item Specifications
Determine whether only MH coding is to be handled
forcibly.
Switches the function of limiting the image compression
to MH codes only.
This setting is required when the line noise affects the
received image.
1) Setting values
ON: MH only
OFF: MMR, MR, or MH is selected depending on
communication capacity
Set the initial value of modem transmission speed.
1) Setting values
33.6/28.8/14.4/9.6/4.8k bps selectable.
Set the T1 timer (call connection wait time: XTTO) for
transmission.
* T1 (TX) is a time to detect up to 3 flags of DIS sent from
a called fax machine.
This timer sets the time that lapses from the moment the
last digit has been transmitted to the moment the line is
disconnected.
1) Setting values
10-255 selectable (in 1 second steps)
* Enter a value using ten-keys.
Set the T1 timer for reception.
The time from issue of the first DIS to issue of a signal is
checked. If a time-out occurs, the line is disconnected.
1) Setting values
10-255 selectable (in 1 second steps)
* Enter a value with ten-keys.
Set the T2 timer.
The T2 timer is an EOL(End Of Line) signal interval timer
used for G3 image reception or an instruction reception
wait timer.
If any signal cannot be detected within the timer-set time,
the fax disconnects the line.
1) Setting values
1-255 selectable (in 100 ms steps)
* Enter a value with ten-keys.
* Actual value = (Set value) x 100 ms
Suppose the set value is 060, then
060 x 100 ms = 6 s
12 MH only
13 High-speed modem rate
14 T1(TX) timer value
15 T1(RX) timer value
16 T2 timer *100ms
Table 2.9.2.3 Technical Functions: Setup (5/11)