|
Handbook
43
05 SENDER ID
This function controls the printing of your fax machine’s
Sender ID on the faxes you send. Refer to the
“Programming Required Information, Fax Identification”
section of this handbook for details. When turned on, the
Sender ID will be printed on each page slightly outside the
image area of your document. The default setting is ON.
!
In order to meet FCC requirements, you must have this
feature set to ON and have a valid Sender ID
programmed in your fax machine.
06 MONITOR VOLUME
This function sets the volume for telephone line
monitoring during dialing.
Available settings are LOW (default), HIGH, and OFF.
07 BUZZER VOLUME
This function sets the volume of the various tones your fax
machine emits during operation. Available settings are
LOW, MIDDLE (default), and HIGH.
08 CLOSED NETWORK
This function allows you to program your fax machine to
refuse to communicate with locations whose telephone
numbers have not been programmed into your One Touch
keys or Auto Dial locations. Using this function, you can
set up a closed network of fax machines. Refer to the
“Security, Rejecting Unsolicited (Junk) Fax Messages”
section of this handbook. If you do not want your fax
machine to transmit faxes to or receive faxes from
locations outside your network, select T/R. If you only
want your fax machine to refuse to receive faxes from
outside your network, select RX.
Available settings are OFF (default), T/R, and RX.
09 TX MODE DEFAULT
Your fax machine is set for the STD (standard) resolution
setting and the NORMAL contrast setting. If you
consistently send faxes that require some other
combination of transmission modes, use this function
setting to change the default modes. While you are
programming, the new default combinations appear on the
lights above the Yes
§
and the No
©
keys. The default is
STD/NORMAL.
