Troubleshooting > 102
through the drum cavity area. Then allow the pressure release lever to rise
again.
9.
Starting with the cyan image drum unit nearest the fuser, replace the four image
drums into the drum cavity, making sure to locate them in the correct order.
Holding the complete assembly by its top centre, lower it into place in the MFP,
locating the pegs at each end into their slots in the sides of the MFP cavity.
10.
Lower the top cover but do not press down to latch it closed yet. This will protect the
drums from excessive exposure to room lighting while you check the remaining
areas for jammed sheets.
11.
Open the rear exit tray (5) and check for a sheet of paper in the rear path area (6).
Pull out any sheets found in this area.
NOTE
If the sheet is well advanced into the fuser (only a short length is still visible),
do not attempt to pull it back. Follow the next step to remove it from the rear
of the MFP.
1. Cyan cartridge
2. Magenta cartridge
3. Yellow cartridge
4. Black cartridge
1
2
3
4
6
5
Summary of Contents for ES5460
Page 1: ...User s Guide ES5460 MFP...
Page 128: ...07099201 iss 1...
