Oki C9800hdn, Configuration Manual, Page: 69 / 168

4
4-17 Network Setup options
IPX/SPX Setup options
For protocols other than IPX/SPX, the frame type is automatically enabled and does
not require setup, as follows:
To specify the frame types the Fiery uses for IPX/SPX protocols, choose IPX/SPX
Setup from the Protocol Setup menu. You must choose at least one frame type to
enable IPX/SPX protocols. The Fiery supports the following frame types for
IPX/SPX:
• For Ethernet—Ethernet 802.2, Ethernet 802.3, Ethernet II, and Ethernet SNAP
With this protocol And these printing services
This frame type is
automatically enabled
AppleTalk PAP (Printer Access Protocol) Ethernet SNAP
TCP/IP with Ethernet LPD (Line Printer Daemon) Ethernet II
Select Frame Types
Enable IPX Auto Frame Type
Yes/No [No]
Specify whether the Fiery should try to bind to all available frame types automatically.
The Fiery does so whether or not all frame types are appropriate. To determine the
frame types that were successfully bound, save your changes, exit Setup, restart the
Fiery, and print a Configuration page. The Configuration page lists only one of the
frame types that were successfully bound.
If you answer No to this option, you can select frame types manually. You must choose
at least one frame type to enable IPX/SPX protocols.
The frame selection screen allows you to make multiple selections. Depending on your
Port Setup selection, only Ethernet frame types or all frame types are displayed.
Press [ENTER] for each frame type used on your IPX/SPX network. An asterisk (*)
appears beside each selected frame type. Press the line selection button again to cancel
a selected frame type. Use the up and down arrow buttons to scroll to additional frame
types. The Fiery binds to each frame type as you select it.
When you have selected all the frame types used, choose Exit IPX/SPX Setup.