Oki C9800hdn, Configuration Manual, Page: 60 / 168

4
4-8 Performing Setup from the Control Panel
T
O ACCESS
N
ETWORK
S
ETUP OPTIONS
1. Confirm that the network cable is connected to the Fiery.
During Network Setup, the Fiery queries the network for zones, servers, and
server-based queues. If you perform Network Setup without a connected and
functioning network, default settings are used that may not meet your needs.
2. Choose Network Setup from the main Setup menu as described on page 4-3 .
3. Choose Port Setup from the Network Setup menu.
4. To use Ethernet, choose Ethernet Setup from the Port Setup menu, and enter the
appropriate settings.
5. To print to the parallel port, choose Parallel Port Setup from the Port Setup menu, and
enter the appropriate settings.
6. When you have finished entering port settings, choose Exit Port Setup, and then
choose Protocol Setup.
7. Enter the appropriate settings for the protocol or protocols you will use.
8. When you have finished entering protocol settings, choose Exit Protocol Setup, and
then choose Service Setup.
9. Enter the appropriate settings for the services you will use.
The options are described in detail in the following section.
T
O EXIT
N
ETWORK
S
ETUP
1. When you have finished entering service settings, choose Exit Network Setup.
2. Choose Yes when prompted to save changes.
3. From the main Setup menu, choose another Setup or choose Exit Setup.
Parallel Parallel Port Setup — —
For this Network or
Connection Type
Use this
Port Setup
Use this Protocol Setup Use this Service Setup