Course Instructions
:
1. The Oki Data A3 printer engine weighs almost 200 pounds, so use caution
and common sense when lifting, moving, or placing it on a surface.
2. Follow the procedures as they are written.
3. If you encounter any problems, notify the instructor.
4.
NOTE
: steel screws go into metal; Black screws go into plastic.
5. Use Electrostatic Discharge precautions when handling the electronics
portions of the printers.
6. Pay very close attention to the wiring harnesses and how they are routed.
This will save time when you reassemble your unit!
7. Pay particular attention to not pinching cable assemblies when
reassembling the unit.
8. Watch for sharp edges and burrs on the metal covers and support
brackets. This machine contains a lot of metal –
Be careful!
9. Store the removed screws with the appropriate assembly they secure.
10. Notify the instructor if you have any left over parts/screws once you’ve
completed the re-assembly. This is
IMPORTANT
since these are training
machines and will be used for additional training classes.
11. We do not “booby trap” machines prior to disassembly or re-assembly.
We may introduce problems after your unit is reassembled and tested:
This is the best way to learn troubleshooting techniques.
12. Learn as much as you can - Enjoy the class – Ask questions
13. Remember;
It Is Your Course
! Ask questions of the instructors.
14. When completing the course critique, be honest; If you find a problem,
want to make a suggestion, utilize the comments section on the rear of the
critique form.
We Do Pay Attention to These Comments!
Remember:
Constructive Criticism is always welcome and it helps us to improve this
course.
III