![background image](http://html1.mh-extra.com/html/oki/c910/c910_service-training_4104261048.webp)
33. Removing the Fuser
Motor
33.1. Remove
two
screws and
unthread wire
harness taking
note of the routing
for reassembly.
Remove the Fuser
Motor.
Congratulations!
This concludes the disassembly of the bottom half
of the 9 Series A3 Printer unit.
Prior to starting the next section (
Top Cover Skin Removal
) reassemble the
bottom half of the printer unit using this step-by-step disassembly manual in
reverse.
NOTE:
Take your time and be very careful when reconnecting the wiring
harnesses to the (1) motor driver board, (2) the engine driver board and (3) when
reconnecting the 2 ribbon cables between the engine and motor controller
boards! A properly reassembled printer contains only one (1) empty red test
connector on the motor driver board!
Take Your Time
when rewiring and
reassembling this printer.
HINT:
If you’re unsure of something – ask one of the
instructors circling the room: it’s easier to ask for help than ask for a replacement
part.
Reassemble the Bottom Half
44