![background image](http://html1.mh-extra.com/html/oki/c910/c910_service-training_4104261047.webp)
32. Removing the OR-SGG
(ID System SNS PWB)
aka Drum Contact and
Sensor Board Assy.
32.1. Remove
four
screws, one each
from the Drum
Position Home
sensors. Use a flat
blade to release
the two Toner
Shutter Home
sensors and the
Drum Up/Down
Home sensor.
32.2. Use a flat blade
screwdriver to
release the tabs
securing the main
portion of the
Drum Contact and
Sensor Board
Assy. and unplug
one connector.
Remove the board
being careful of the
drum contact
springs as they
may fall out.
NOTE: There are 2
Grounding Springs (red
arrows, at right) that ground
the OR-SGG board to the
chassis ground.
You Must
insure that both of these
springs are correctly installed
during the reassembly
process.
43