Parts adjustments and replacements
24
7.1
Replacing and Adjusting the Brush
CAUTION:
Turn OFF the power switch before starting replacement and adjustment.
If the brush is too worn to sweep screws off of the rail, replace it.
A brush with harder bristles, than the standard brush, is available as an option.
1.
Turn ON and OFF the power switch in order to set the brush at the position shown in the
figure on the right and detach the brush assembly.
2.
The brush assembly can be disassembled as shown in the figure below.
3.
After completing the assembly, check that the front part of the brush doesn’t come in
contact with the passing plate. The ideal clearance is 0mm.
For assembly, reverse the disassembling procedure.
Adjustments and checks before use page 10
Part number of brush assembly:
•
OHTAKE - NSB 02053, OnRobot - 104849 #01 (standard brush)
•
OHTAKE NSB 02053, OnRobot - 104850 #02 (optional, harder bristle brush)
Brush assembly attaching screw
Passing plate
Brush
assembly
Passing
plate
Brush
When the brush is operating, it should not
come in contact with the passing plate.
(Exploded view)
Hex socket head small bolt M2.6x10
Spring washer M2.6
Plain washer M2.6
Brush bracket #1
Brush
Brush bracket #2
