Adjustments and checks before use
15
5.4
Checking and adjusting the passing plate
CAUTION:
Turn OFF the power switch before making any checks or adjustments.
1.
Check that the passing plate is adjusted to a height that permits loaded screws to pass
just within the clearance limit.
If the passing plate is too low, screws cannot pass. If the passing plate is too high, it will
hamper a smooth transport of the screws.
2.
If adjustment is required, loosen the passing plate attaching bolt and adjust the height.
3.
After making an adjustment, do an operational check.
NOTE:
Using the half-presses on both sides of the passing plate as guides, slide the
passing plate up or down.
The clearance should be just enough to permit the loaded screws to pass through the passing
plate.
Passing plate attaching bolt
Passing plate
Half-press (provided on both sides of
the passing plate)
Loaded screw
