Adjustments and checks before use
12
5.2
Basic operation
5.2.1
Amount of screws to be loaded
1.
Turn the power switch ON and OFF so that the scooping block is at the lower limit
position.
2.
Load screws up to approximately 2
～
3mm below the rail surface.
3.
At this time, check that screws are not loaded so as to cover the upper portion of the
inclined plate.
4.
Be sure to determine the screw load by observing the machine while it is in operation.
CAUTION:
An excessive amount of screws, loaded into the chamber, will have an adverse
effect on the screw alignment and transport.
The figure, shown below, indicates the maximum amount of screws to be loaded.
Use this as a guide when loading the screws.
Screws, loaded into the chamber, must not be above the rail-groove surface.
(The maximum screw load must be 2 to 3 mm below the rail-groove surface.)
Power switch
This inclined surface, on both the right
and left inclined plates, should be
visible.
