Adjustments and checks before use
10
5
Adjustments and checks before use
5.1
Checking the model number of the body
Check if the machine has the parts which match the nominal diameter of the screws to be
loaded. Check the model number of the rail, escaper, escaper guide for the robot and
passing plate by referring to the following table. Each escaper is stamped with a model
number which matches with the type of screws that can be used. The escaper guide for the
robot is stamped with a model number which corresponds with the types of screws that
can be used.
Before delivery, each section of the machine is checked and adjusted with panhead screws
matching the nominal diameters of the ordered model.
Most screws may be usable in the initial status of adjustment however, if the height or
shape of the screw head is different or if the operation is regarded as abnormal, each
section must be readjusted. If this is the case, make the following checks and adjustments:
•
Check the screw load amount
•
Check and adjust the passing plate
•
Check and adjust the holding plate
•
Check and adjust the timer
•
Check and adjust the brush
•
Check and adjust the rail vibration
•
Check and adjust the front and rear sides of the rail
Rail
identification
seal
Passing
plate
identification seal
Escaper guide for the
robot identification
stamp
Escaper
identification stamp
